Pre-cast concrete formwork is a form of concrete that sticks, and its thickness is about 45 -70 cm. Later we cast in bottom reinforcement and duct formers in the form of electrical boxes, electrical duct formers to gypsum board walls, shafts, safety-railing holds, stop ends and more. To be able to lift the elements in place we cast in lattice girder reinforcement, which also works as basis for the top reinforcement. The standard widths are 1200 respectively 2400 mm, but the elements are designed and adjusted after the object unique conditions.

The pre-cast concrete formwork has many different areas of use. It mainly used when constructing new houses, but works just as well for offices, schools, hospitals and other applications.

There are different types of pre-cast concrete formwork: reinforced pre-cast concrete formwork, pretension pre-cast concrete formwork and precast concrete formwork beams.

The pre-cast composite wall elements consist of two separately casted elements with a thickness of 50 mm, adherent with infused lattice girder reinforcements. When the walls are founded against steel forms you get a nice surface that demands minimal after treatment. The walls are already reinforced when delivered; the only thing that needs to be complimented is a wire-mesh reinforcement that will be put in the seam between the walls. We can manufacture sizes from 180 -400 mm, and then we cast them at the construction site. The space inside the wall, where the infusing is made, is 80 -300 mm depending on the thickness of the wall. Even in pre-cast concrete formwork wall panels, we infuse necessary electrical boxes, duct formers, cases for form ties and more.

If you would like some more help with construction, advice or smart solutions, don hesitate to give us a call The earlier the better.